![]() It is incremented when the NIC receives a packet that is unicast but destined to a different destination address. Ignored: refers to packets that did not match the local MAC address. RX Packets: refers to the total number of packets received by the NIC hardware. ![]() The exanic-config utility will display the packet counter values for traffic being transmitted or received at a particular port. Interface packet counters Packet counters in exanic-config See the output ofĮxanic-config -help for more details. ![]() Ports 0-3 inclusive on any SmartNICs installed. Globbing syntax is also accepted in order to exanic0įor the first SmartNIC in the system by PCI ID, and exanic0:0 for theįirst port of that card). eth7) or the device name of the SmartNIC device (e.g. The exanic-config utility will either accept the Linux interface name Port status: enabled, SFP present, signal detected, link active Temperature: 53.2 C VCCint: 1.00 V VCCaux: 1.81 V The exanic-config utility can be used to inspect diagnostic informationĪbout the card and SFP modules. (libexanic) only, it is sufficient to bring the interface up withoutĪssigning an IP address. If the interface is being used through the low-level userspace API Performed using files in the /etc/sysconfig/network-scripts directory.Īlternatively, the interface can be configured temporarily by issuing aĬommand such as ifconfig eth7 192.168.1.100. ForĮxample, in Redhat-based distributions, configuration is generally ![]() Since the Cisco Nexus SmartNIC (formerly ExaNIC) appears to Linux as a normal network card, mostĬonfiguration can be performed through the normal Linux mechanisms. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. Archives
June 2023
Categories |